1. Device Features & Layout

​

Your radionic machine includes these key components:

• Three Calibration Dials (Green/Yellow/Red)

• Witness Plate (Left Side) - For placing biological samples or photographs

• Stick pad (right side) - a tactile feedback mechanism

• 3.5mm Aux Output Jack

• USB Power Port

• Power Switch with LED Indicator

​

2. Getting Started with Energy Work

​

Basic Operation:

1. Connect the USB power cable (5V adapter not included)

2. Flip the power switch - white LED confirms activation

3. Place your witness sample (hair, photo, etc.) on the left side plate

4. Set your desired frequency using the three dials

​

A 3-dial radionics machine has three adjustment knobs:

​

1. Coarse Dial (Left or First Dial) – Sets the broad category or general energy pattern.

2. Medium Dial (Middle or Second Dial) – Refines the energy within the coarse setting.

3. Fine Dial (Right or Third Dial) – Fine-tunes to the most precise frequency.

​

Begin by setting all three dials to 0 or their neutral position.

 

Finding the Correct Rate

Now, think clearly about your target—whether it’s a person, condition, or intention. With your free hand, gently rub the stick pad in a circular or back-and-forth motion while slowly turning the Coarse Dial. At some point, you may feel a slight drag, stickiness, or resistance under your finger. This indicates a possible match.

Once you detect this change, hold the Coarse Dial in place and repeat the process with the Medium Dial, turning it slowly until you feel another sticky response. Finally, adjust the Fine Dial in the same way until the stickiness is strongest.

 

Confirming the Rate

To verify the correct setting, reset all dials to zero and try finding the same combination again. If the stickiness repeats at the same numbers, the rate is confirmed. Some practitioners also use pendulums or muscle testing for additional validation.

 

Broadcasting or Analyzing

If you are using the machine for analysis, the confirmed rate can indicate imbalances or energetic patterns in the target. If you are broadcasting (sending energy), leave the dials set and connect the machine to an antenna, broadcast plate, or visualization to direct the energy. Some devices have an output for this purpose.

 

Closing the Session

Once finished, reset all dials to zero and clear the witness well (if used). Some operators discharge residual energy by briefly touching a grounding wire or wiping the stick pad.

 

Additional Tips

• Practice improves sensitivity to the stick response.

• Keep notes of successful rates for future reference.

• Cleanse the device periodically, either energetically (with intention) or physically (with a mild wipe).

 

Enhanced Applications:​

• Connected Mode: Link to other devices via 3.5mm cable. Other radionic devices can be used to complement the healing performed through the 3 dial radionics machine.

​

3. Optimizing Your Sessions

​

For Best Results:

1. Cleanse your workspace before use (sage, sound, or intention)

2. Place the sample on the witness plate

3. Set dials according to your chosen radionic rates

4. Allow 15-30 minutes for energy transmission

5. Clean the witness plate between different subjects

 

Advanced Technique:
Combine with pendulum or muscle testing to verify optimal dial settings

​

4. Maintenance & Care

​

• Wipe the witness plate with a soft cloth after each use
• Store in a protective case when traveling
• Avoid extreme temperatures or moisture

​

5. Technical Specifications

​

• Power: 5V USB (500mA minimum)

• Output: 3.5mm stereo jack

• Dimensions: 135x195x36mm (5.30" x 6.66" x 1.41")

• Materials: plastic housing, anodised aluminium dials, gold plated pads and antennae